EMX CarSense 101 and Probes Manuals & Support

EMX CS101

The EMX CarSense 101 is a plug-in vehicle motion detector that works with a buried probe instead of a saw-cut loop. It detects vehicles up to 12 ft from the probe at 5 mph or more.

It plugs into an 11-pin socket, runs on 9 to 41 VDC or 6 to 29 VAC and has a Form C relay with an adjustable 0.5 to 6 second output time. Probes come with 50 to 200 ft lead-in.

Buy the CS101 (5 options)

Identify your model

The CS101 detector plugs into an LD-11 11-pin socket. The probe is a 17 in PVC tube with shielded 3-wire direct burial cable. Probe length is in the part number, such as PROBE-100 for 100 ft of lead.

Key specs

Detection Up to 12 ft at 5 mph minimum
Power 9 to 41 VDC or 6 to 29 VAC
Current 2.5 mA standby, 50 mA detect
Relay Form C, 1 A at 24 VDC or 115 VAC
Output time 0.5 to 6 seconds
Connector 11-pin
Probe 17 x 1 in PVC, shielded direct burial cable
Operating temperature -40 to 180 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

False triggering

  • Connect the earth ground and the probe shield to terminal 6.
  • Disconnect the probe. If false calls continue, test on a 9 or 12 V battery; a clean power supply may be needed.
  • Look for moving metal or electrical noise near the probe.

Red LED shows detect but no output

  • Check the output wiring and the relay.

No detection

  • Vehicles must pass at 5 mph or more.
  • Check power and probe wiring. Replace the probe if it is damaged.

Common questions

No. The CarSense 101 senses moving vehicles at 5 mph or more.

Pick the lead-in that reaches the detector without a splice: 50, 100, 150 or 200 ft.

A standard 11-pin socket such as the LD-11, or an 11-pin harness.