EMX IRB-MON and IRB-MON2 Photo Eyes Manuals & Support

EMX IRB-MON / IRB-MON2

The EMX IRB-MON and IRB-MON2 are universal UL 325 thru-beam photo eyes for gates and doors with a range up to 115 ft.

The IRB-MON2 is the current model. It supports normally closed, 10K and 2-wire pulse monitoring, has removable terminals and runs on 6 to 35 VDC or 12 to 24 VAC.

Buy the IRB-MON / IRB-MON2 (2 options)

Identify your model

Both have a separate transmitter and receiver. The IRB-MON has a green power LED and a green detect LED. The IRB-MON2 has removable screw terminals and a 4-position DIP switch for the monitoring method. Early IRB-MON units have a blue board; use the blue board manual for those.

Key specs

Type Thru-beam
Range Up to 115 ft
Monitoring NC, 10K, 2-wire pulse
Power 6 to 35 VDC or 12 to 24 VAC
Relay Form C
Enclosure NEMA 4X
Operating temperature -40 to 170 °F
Hood option IRB-MON2-HD gray metal hoods

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Receiver LED status (IRB-MON2)

  • Solid green: aligned.
  • Flashing green: beam blocked or not aligned.

Aligning

  • Turn the receiver sensitivity up until the LED is solid, back it off until it starts to flash, then add a quarter turn.

Aligned but does not see an obstruction

  • On short spans under about 20 ft, lower the receiver sensitivity until a hand in the beam is detected.

Operator does not see the photo eye

  • Set the DIP switches for the monitoring method the operator uses: NC, 10K or pulse.
  • Test with an obstruction at several distances and check the operator input.

Common questions

The IRB-MON2 is the newer version. It adds removable terminals and DIP switch selection of NC, 10K or pulse monitoring.

It works with operators that accept a monitored external entrapment device. Check the operator manual for the monitoring method it needs, then set the photo eye to match.

Up to 115 ft between the transmitter and receiver.