EMX IRB-RET Photo Eye Manuals & Support

EMX IRB-RET

This model is discontinued. The current replacement is the EMX IRB-RET2 RETROREFLECTIVE PHOTOEYE. Manuals and replacement parts for existing units are listed below.

The EMX IRB-RET is a universal UL 325 retroreflective photo eye for gates and doors with a range up to 60 ft.

It has three output modes: relay output and 2-frequency or 3-frequency pulse. It runs on 6 to 40 VDC or 12 to 24 VAC. EMX has replaced it with the IRB-RET2.

Buy the IRB-RET

Identify your model

The IRB-RET is a tall housing with a separate reflector and 9 screw terminals. The newer IRB-RET2 has a ball and socket bracket and six monitoring methods.

Key specs

Type Retroreflective
Range Up to 60 ft
Modes Relay, 2-frequency pulse, 3-frequency pulse
Power 6 to 40 VDC or 12 to 24 VAC
Current 15 mA pulse mode; 60 mA relay mode
Relay Form C, 10K across NO selectable
Enclosure NEMA 4X
Operating temperature -40 to 140 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Gate will not run

  • Check that the mode switch matches the operator monitoring method.
  • Check the beam is aligned. The red detect LED shows alignment.

Drops out in weather

  • Turn up the sensitivity potentiometer.
  • Clean the lens and reflector.

Common questions

The EMX IRB-RET2. It adds more monitoring methods, an alignment LED and a ball and socket bracket.

It works with operators that accept a monitored external entrapment device. Check the operator manual for the monitoring method it needs, then set the photo eye to match.

Up to 60 ft between the photo eye and the reflector.