Linear BGUS Barrier Gate Operator Manuals & Support

Linear BGUS

The Linear BGUS is a counter-weighted barrier gate operator for 14, 16 or 18 ft arms. It has a 1/2 HP motor on 115 or 230 VAC and opens in about 11 seconds.

It uses the APeX 24 VDC controller with a built-in MegaCode receiver, cam operated limits and an oil bath gear reducer, and is rated for continuous duty.

Buy the BGUS (6 options)

Identify your model

BGUS-16-211 is a 16 ft arm on 115 VAC; -221 is 230 VAC. The DC battery backup version is the BGUS-D.

Key specs

Motor 1/2 HP
Power 115 or 230 VAC
Arm 14, 16 or 18 ft counter-weighted wood arm
Open time About 11 seconds
Duty Continuous
Controller APeX 24 VDC with integral MegaCode receiver
Approvals UL 325 and UL 991

Manuals and documents

Installation Manual

Wiring Diagram

Spec Sheet

Other documents

Troubleshooting

The APeX controller shows status on its 2-digit display and LEDs. Press STOP to clear most errors once the cause is fixed.

Error codes

  • En 00: two safety reversals in a row. Clear the obstruction and press STOP.
  • En 01 or En 02: maximum run timer ran out while opening or closing. Check for a broken chain or belt, a slipping pulley or a timer set too low.
  • En 03: dual gate COMM LINK failure. Check the 3-wire shielded cable between operators.
  • En 04: battery dropped below 21.6 VDC after AC power loss. Restore AC power and let the batteries charge.
  • En 07: low AC voltage at the controller. Restore normal supply voltage.
  • En 10: EEPROM problem. Try a reset.
  • En 11: DC motor check failed. Reprogram the motor type.

Operator fails to start

  • The motor thermal overload may have tripped after many cycles. Let it cool and it resets.
  • Check power at the breaker panel.

Gate stops part way with no obstruction

  • Current sensing set too low. Make sure the gate moves freely, then raise the setting.
  • An accessory on the obstruction input triggered. Disconnect devices one at a time to find it.

Motor runs but gate does not move

  • Check the torque limiter for slipping and tighten it if needed.
  • Check for a broken chain or worn belts and loose set screws or keys.

Common questions

Yes. The APeX controller has an integral MegaCode receiver that learns up to 40 Linear MegaCode transmitters.

The operator saw two safety reversals in a row and locked out. Clear the obstruction, then press STOP to reset.

The BGUS is for longer, counter-weighted arms of 14 to 18 ft and opens in about 11 seconds. The BGU is a fast barrier for 10 to 14 ft arms.