Miller Edge CPT210 Field Configurable Edge Manuals & Support

Miller Edge CPT210

The Miller Edge CPT210 is a sensing edge you cut to length and assemble on site. It has a slim 1 in profile for narrow surfaces and pinch points.

Color-coded end plugs set or identify the monitoring type, and the sealed end design needs no adhesive. It is UL 325 recognized.

Buy the CPT210

Identify your model

The CPT210 kit includes the edge extrusion, color-coded end plugs and the ME210-C7 mounting channel. The plug color shows the monitoring type.

Key specs

Profile 1 in
Length Cut to length on site
Monitoring Set with color-coded end plugs, monitored or non-monitored
Technology Conductive polymer
Approvals UL 325 recognized, CE

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Edge does not signal

  • Check that the end plug matches the operator monitoring type.
  • Read the edge with an ohmmeter at rest and when pressed.
  • Make sure the end plugs are fully seated after cutting.

Common questions

Yes. Cut the extrusion on site and seal it with the end plugs.

Use the color-coded end plug for the type the operator needs.

Disconnect it and read it with an ohmmeter. A 10K edge reads about 10,000 ohms at rest and drops near zero when pressed. A 2-wire normally open edge reads open at rest and near zero when pressed.