Miller Edge ME110 Sensing Edge Manuals & Support

Miller Edge ME110

The Miller Edge ME110 is a small profile sensing edge for rolling counter shutters, grilles and doors up to 1 in thick. It also guards machines and conveyors.

It slides into a mounting channel, mounts vertically or horizontally and is a UL 325 recognized component.

Buy the ME110 (2 options)

Identify your model

The ME110 is a black, low-profile edge. Kits come in 4 ft and 5 ft lengths with channel.

Key specs

Profile For doors up to 1 in thick
Max length Electric 50 ft
Activation force 4 to 7 lbf nominal
Lead SJTO 22 AWG
Approvals UL 325 recognized component

Manuals and documents

Installation Manual

Spec Sheet

Other documents

Troubleshooting

Gate or door does not stop on contact

  • Read the edge with an ohmmeter. A 10K edge reads about 10K ohms at rest and near zero when pressed. A 2-wire NO edge reads open at rest.
  • Check the lead wire and outlet for damage.
  • Make sure the edge type matches the operator input.

Edge slides in the channel

  • Drill a 1/8 in hole in the channel 2 in from the end and add a #10 pan head screw to hold the edge.

Common questions

Rolling counter shutters, grilles, thin doors up to 1 in, and machine guarding.

Disconnect it and read it with an ohmmeter. A 10K edge reads about 10,000 ohms at rest and drops near zero when pressed. A 2-wire normally open edge reads open at rest and near zero when pressed.

It slides into a Miller Edge channel. The 4 ft and 5 ft kits include the channel.