Seco-Larm E-931-S33PRGQ Polarized Photo Beam Manuals & Support

Seco-Larm E-931-S33PRGQ

The Seco-Larm E-931-S33PRGQ is a polarized reflective photo beam with a 33 ft range. It only responds to light returned by its reflector, so shiny vehicles do not fool it.

It runs on 12 to 30 VAC or VDC, has N.C. and 10k ohm monitored outputs, a tamper switch and an IP55 housing. The sensor swivels 90 degrees left or right.

Buy the E-931-S33PRGQ

Identify your model

The sensor LED shows solid green when aligned, alternating when weak and solid red when blocked. It replaces the E-931-S33PRQ.

Key specs

Range Up to 33 ft
Type Polarized reflective
Operating voltage 12 to 30 VAC or VDC
Current draw 55 mA standby, 40 mA active at 12 VDC
Output SPDT relay, 500 mA at 30 VAC/VDC
Monitoring N.C. or 10k ohm
IP rating IP55
Operating temperature -4 to 131 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Sensor does not detect

  • Change the sensor angle or readjust the sensitivity.
  • Shiny objects can reflect the beam back. Use a polarized sensor where shiny vehicles pass.

Alignment LED will not show a good signal

  • Clean the sensor lens and reflector with a damp cloth.
  • Re-aim the sensor and reflector so the beam lands in the center of the reflector.

LED shows a trip but the gate or panel does not respond

  • Check the wiring between the sensor relay and the operator or panel input.
  • On monitored inputs, use the output type the operator expects: N.C. or 10k ohm.

Common questions

A polarized sensor ignores light bounced off shiny paint or chrome, so it still trips when a shiny vehicle breaks the beam.

Yes. It has N.C. and 10k ohm monitored outputs.

Yes.