LINEAR OSCO GSLG-A-483 3/4HP SLIDE GATE OPERATOR

• Integral APeX Controller
• Direct motor to gear reducer drive
• C-face brake
• #50 roller chain
• Emergency manual disconnect handle
• Powder coat finish
• Post mount standard; pad mount optional

Electrical

• Solid state 24V control board UL325/UL991 compliant
• Diagnostic LED display for ease of setup and trouble shooting
• Integral entrapment sensing system with digital set point for accurate adjustment and enhanced safety
• Integrated maximum run and auto close timers
• Built-in dual gate capability using 3-wire shielded cable
• 24V DC power available for access control accessories
• Continuous-tone entrapment alarm with reset button
• Integrated warning beeper during gate movement
• Selectable pre-start alarm with provision for ADA compliant visual pre-start and run alarm

Mechanical

• Heavy-duty 15:1 right-angle C-face gear reducer
• #50 roller chain and sprockets
• Heavy-duty steel chassis
• Heavy-duty pillow-block bearings
• Adjustable torque limiter

• Max Gate Length: 60 ft
• Max Gate Weight: 1,400 lb
• Motor: 3/4 HP
• Input Power: 208 VAC three-phase
• Operating Voltage/Accessory Power: 24 VDC accessory power
• Duty Cycle: Continuous
• UL 325 Class: Class I, II, III and IV
• Battery Backup: Not available
• Solar Capable: No
• Drive: Direct motor to 15:1 C-face gear reducer, #50 roller chain, double C-face brake
• Gate Speed / Open Time: About 12 in per second
• Mounting: Post mount standard; pad mount optional

Power Wiring

• Electrical Connections: All AC electrical connections to the power source and the operator must be made by a licensed electrician and observe all national and local electrical codes; use copper wire only
• Wire Run: Distance is measured in ft from the operator to the power source; do not exceed the maximum distance for the model, voltage, horsepower and wire gauge
• Basis: Based on standard 115 V and 230 V supplies with a 10% drop allowable, per National Electrical Code Article 430 (motor inrush, brake solenoids and operator requirements)
• Junction Box: A separate junction box (not supplied) may be needed when large-gauge wire is used
• Ground: The green ground wire must be properly connected

Mounting Pad Installation

• Mounting: Bolted to two 3 - 3-1/2 in OD galvanized posts secured in concrete footings (length per local codes, frost line depth and soil conditions); optional pad mounting per Linear drawing #2700-360
• Side Plates: Four 3/16 in side plates on the outside top and bottom, two 1/2 in side plates on the inside top, two 3/16 in side plates on the inside bottom; attached with the U-bolts and hardware provided
• Gate Preparation: Gate must roll or slide freely with exposed rollers covered; gate covered with fabric with openings no larger than 2-1/4 in to a minimum height of 72 in above ground (mesh optional on picket gates with pickets less than 2-1/4 in apart)
• Pedestrians: Operator is for vehicular gates only; a separate pedestrian access opening must be supplied

Spec Sheet

Installation Manual

Electrical Wire Specs

GSLG-A Mounting Instructions

Slide Gate Loop Layout