Miller Edge MGO20 Sensing Edge Manuals & Support

Miller Edge MGO20

The Miller Edge MGO20 is a three-sided slide-in sensing edge for gates and doors. It activates from the front and both sides, which suits slide gate draw-in posts, pivot points and barrier arms.

It fits 1-1/2 in gate surfaces, mounts vertically or horizontally in a channel and is a UL 325 recognized component.

Buy the MGO20 (2 options)

Identify your model

The MGO20 is narrower than the ME120 and responds on three sides. It installs the same way as the ME120.

Key specs

Activation 3-sided
Profile For 1-1/2 in gate surfaces
Mounting Slide-in channel, vertical or horizontal
Monitoring Monitored or 2-wire versions
Approvals UL 325 recognized component

Manuals and documents

Installation Manual

Spec Sheet

Brochure

Troubleshooting

Gate or door does not stop on contact

  • Read the edge with an ohmmeter. A 10K edge reads about 10K ohms at rest and near zero when pressed. A 2-wire NO edge reads open at rest.
  • Check the lead wire and outlet for damage.
  • Make sure the edge type matches the operator input.

Edge slides in the channel

  • Drill a 1/8 in hole in the channel 2 in from the end and add a #10 pan head screw to hold the edge.

Edge arrived bent

  • MGO20 edges must stay straight and flat. Do not fold them.

Common questions

The MGO20 senses on three sides, which helps at draw-in posts and pivot points. The ME120 is a two-sided edge for leading edges.

Disconnect it and read it with an ohmmeter. A 10K edge reads about 10,000 ohms at rest and drops near zero when pressed. A 2-wire normally open edge reads open at rest and near zero when pressed.

No. Keep the MGO20 straight and flat.