BEA LZR-S600 Laser Scanner Manuals & Support

The BEA LZR-S600 is a laser time-of-flight scanner with four laser curtains that create a 3D presence zone. It has the largest field in the BEA LZR line.

It is used for perimeter security, large industrial doors and gates and mass transit. It has an IP65 housing, two electronic relays and three visible laser spots for aiming.

Buy the 10LZRS600

Identify your model

The LZR-S600 is the large-field LZR scanner. See the comparison chart below for the LZR-H100, LZR-I30 and LZR-WIDESCAN.

Key specs

Technology	Laser scanner, time of flight, 4 curtains
Power	10 to 35 VDC, under 5 W
Outputs	2 electronic relays, 35 VDC / 24 VAC, 80 mA
Inputs	2 optocouplers
Response time	Typical 20 ms
Cable	33 ft
Enclosure	IP65

Manuals and documents

Troubleshooting

No blue LED

No power, or the power polarity is reversed.
LEDs may be turned off by remote. Turn them on with the remote.

Only the blue LED is on

The test input is not connected. Connect it to the test output or to power.

Detection LED stays red

Something is in the field, or the field touches the floor, wall or door. Turn on the red aiming spots, adjust the tilt and run a Learn.

Orange LED flashing, detection LEDs red

No background reference found. Check the mounting position and side setting, then run a new Learn.

Common questions

10 to 35 VDC measured at the sensor, under 5 W.

Turn on the three red laser spots with the remote and adjust the tilt with the hex screws, then run a Learn.

The field may touch the floor, a wall or the door, or something is in the field. Re-aim it and run a Learn.

Safety devices and accessories

BEA 10REMOTE Universal Remote Control

BEA