EMX IRB-4X and IRB-4X2 Photo Eyes Manuals & Support

EMX IRB-4X / IRB-4X2

The EMX IRB-4X and IRB-4X2 are thru-beam photo eyes with a range up to 115 ft and a dry contact relay output. They work with any control that accepts a dry contact input.

They are not monitored devices. Do not use them as the required UL 325 entrapment protection on gate or door operators that need monitored sensors. The IRB-4X2 is the current model.

Buy the IRB-4X / IRB-4X2 (2 options)

Identify your model

The IRB-4X has separate hoods. The IRB-4X2 has built-in hoods, removable terminals and a red obstruction LED on the receiver. For monitored UL 325 use, see the IRB-MON2.

Key specs

Type Thru-beam, non-monitored
Range Up to 115 ft
Power 12 to 24 VDC or 24 VAC
Relay Form C, 1 A at 24 VDC
Response time 10 ms
Operating temperature -40 to 170 °F
UL 325 Not for applications that require monitored devices

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

LED status (IRB-4X2)

  • TX green: power.
  • RX green: power.
  • RX red: beam blocked or not aligned.

Does not detect an obstruction

  • Sensitivity is too high or the beam reflects off another surface. Lower the receiver sensitivity on spans under about 20 ft.

False trips near drives

  • On noisy sites or near variable frequency drives, connect the receiver earth ground hole to earth ground.

Common questions

No. It has a dry contact output only. Use a monitored photo eye such as the IRB-MON2 or IRB-RET2 where the operator requires monitored devices.

Reversing or opening inputs on garage doors, rolling doors, parking barriers and older operators that accept a dry contact.

Up to 115 ft.