AES e-Loop In-Ground Wireless Vehicle Sensor Manuals & Support

AES EL00IG / EL00IG-K / EL00IG-RAD / EL00IG-RAD-K

The AES e-Loop In-Ground is a flush mount wireless vehicle sensor set in a 3.5 in core-drilled hole. It signals the e-Trans transceiver, which opens the gate. No saw-cut loop or trench.

The EL00IG is for exit mode. The EL00IG-RAD adds radar and comes set to presence mode. The 14,500 mAh battery lasts 6 to 10 years and is replaced from the top.

Buy the EL00IG / EL00IG-K / EL00IG-RAD / EL00IG-RAD-K (4 options)

Identify your model

EL00IG and EL00IG-RAD: sensor only. EL00IG-K and EL00IG-RAD-K: kits with the ETRANS50 transceiver. Coding uses the supplied magnet.

Key specs

Hole 3.5 in core, 2.6 to 2.75 in deep
Radio 433.39 MHz, 128-bit AES, up to 164 ft
Battery 14,500 mAh, 6 to 10 years
Rating IP68
Mode Exit (EL00IG), presence with radar (EL00IG-RAD)

Manuals and documents

Installation Manual

Other documents

Troubleshooting

Sensor does not trigger

  • Code the sensor to the transceiver again.
  • Recalibrate with no vehicle near the sensor.
  • Check the sensor batteries.

Error LEDs

  • Run the test mode and compare the LEDs to the AES LED display guide.

Common questions

A 3.5 in core drill and a sealing compound such as Sikaflex.

Yes. It comes set to presence mode and can be set to exit mode.

No. AES says not to use presence mode as a personal safety device.