BEA IS40 and IS40XL Sensors Manuals & Support

BEA 10IS40 / 10IS40XL

The BEA IS40 is a dual technology motion and presence sensor for industrial doors. Microwave radar opens the door and active infrared holds it open while someone is in the zone.

The IS40 mounts 8 to 16 ft high and the IS40XL 6 ft 6 in to 11 ft 6 in. Both have two relays and an IP65 housing.

Buy the 10IS40 / 10IS40XL (2 options)

Identify your model

The IS40 and IS40XL share one housing. The model is on the label. Settings are made with push buttons or the BEA remote.

Key specs

Technology 24.15 GHz microwave plus active infrared
Mounting height IS40: 8 to 16 ft; IS40XL: 6 ft 6 in to 11 ft 6 in
Max field IS40: 13 x 16.5 ft
Outputs 2 relays, 42 VAC/VDC, 1 A
Power 12 to 24 VAC or VDC, under 3.5 W
Enclosure NEMA 4 / IP65
Cable 32 ft
Operating temperature -22 to 140 °F

Manuals and documents

Installation Manual

Programming Guide

Spec Sheet

Other documents

Troubleshooting

Door never closes, red LED on

  • Objects are in the infrared field. Remove them or shorten the learn time, then run setup.

Door stays closed, LED off

  • Check power and wiring.

Door opens and closes over and over

  • Secure the sensor. Set unidirectional mode. Increase the tilt angle and detection filter. Reduce the field.

Door opens for no reason

  • Rain or vibration: set unidirectional mode and raise the detection filter.
  • Reflective area: change the antenna angle, raise the filter and reduce the field.

Pedestrians still detected with the vehicle filter on

  • Raise the detection filter, decrease the sensor angle or mount it higher.

Infrared does not react

  • The mounting height is too high for the infrared power. Lower the sensor and run setup from outside the field.

Common questions

Use the IS40 for mounting heights of 8 to 16 ft and the IS40XL for 6 ft 6 in to 11 ft 6 in.

Yes. Use the vehicle detection filter, and raise it if pedestrians are still detected.

Use the push buttons on the sensor or a BEA universal remote control.